The Clockmaster's Mk.V Portable Steam-Torch

---

What you'll need:

Small, flashlight found at local hardware stores.

Empty Soda Can

Silver, Brass, or Bronze Mettalic spray-paint.

4 screws, fairly small.

A cheap Hacksaw found at the local hardware store.

Superglue of your choice

2 Peices of sandpaper, 1 course, 1 fine

Safety Goggles

Exacto Knife or box cutter

Permanent Marker

The Build:

1. Cut the top and bottom off of the can with the exacto knife, then cut the alluminum tube straight up and down.

2. Flatten the alluminum with a brick, meanwhile get your 4 screws and hacksaw.

**!!Put on Your Safety Goggles!!**

3. Saw the tops off of the screws with the hacksaw, be careful when you pick them up and quickly put them in a bowl of water.
4. Take your flat peice of alluminum and your flash light.  First, put the flash light on the alluminum and clearly mark the height of the light with your marker, and then make a straight box that you would see big enough to wrap the flash light in.

5. Put superglue in a straight line along the length and quickly line up the aluminum for wrapping.

6. Once the superglue has dried, continue to wrap the light. once you can no longer wrap the light, superglue it into place.

7. Take the screw heads that you sawed off earlier and superglue them about 0.5 centimeters from the line of overlap, on the upper side, like in the picture at the top. of the page.

8. Finally, spray paint the light, but be sure to put masking tape over the light emitting glass peice.  Once the paint is dry, remove the tape and you have a steampunk "Clockmaster's Mk.V Portable Steam-Torch"